Prima Syncrono 1530 HS 4000 watt Laser Cutting System and Shuttle Table NEW: 2008 SPECIFICATIONS: Table size………………….5′ x 10′ X-Axis travel……………..120 inches Y-Axis travel……………..60 inches Z-Axis travel……………..5 inches Approx. weight………….40,000 Lbs Type of resonator………Prima EQUIPPED WITH: CNC PRIMACH-20L Controller Laser Resonator 4000 Watt Dust Collector L-Cut 2-5P (1500cfm, supplied by Keller) Compact Tower w/10 Shelves, Single shelf capacity 6,600 lbs Integrated over the Pallet Changer Laser Ancillary Equipment (Water Chiller, Air Dryer) Safety Enclosure Cutting Head with Capacitive Sensing Safe Impact Protection System Lens Holder (Includes 5.00’’ and 7.5’’ lenses) Automatic Focusing Control (F-axis) Programmable High Pressure Assist Gas with Two Ports (300 psi) Automatic Sheet Referencing System Automatic Switch Off System Ducted and Zoned Cutting Table Dual Pallet Shuttle Table Uses NC Express programming software Quick Pierce System Laser Piercing Monitor DESCRIPTION: The laser allows to cut thin material with higher speed. The dynamics of traditional machines, however, are not adequate to exploit this higher performance: the laser allows higher speeds, but the conventional machine cannot keep up. With its unique and revolutionary architecture and its 6 g acceleration, SYNCRONO is the only machine on the market which can match the dynamics necessary to laser technology on thin sheets. Also the energy efficiency of the SYNCRONO (small masses execute faster movements), is further enhanced with laser. This technology allows a drastic reduction of the electric consumptions, thanks to the use of lower powers and to the high efficiency of the source, thanks to the simplicity of the laser, without turbine and filters and with reduced optical chain. Laser allows a widening of the range of materials which can be cut with SYNCRONO, including high reflecting ones, such as brass and copper **BUYER RESPONSIBLE FOR VERIFYING SPECIFICATIONS** **35,873 HOURS** **REPLACEMENT COST NEW: $1,078,460.00**