602-516-4267

2006 TECHNIDRILL BTA-4.00-60-1A-PLC-90-CR GUNDRILL

2006 TECHNIDRILL BTA-4.00-60-1A-PLC-90-CR GUNDRILL

Request Quote
SKU: technidrill-bta-4-00-60-1a-plc-90-cr-gundrill Category: Tags: ,

Description

TECHNIDRILL BTA-4.00-60-1A-PLC-90-CR GUNDRILL
NEW: 2006

SPECIFICATIONS:
Drilling capacity (Dia.)……………….0.500″ To 4.00″
Drilling capacity (depth)………………90″ with two optional whip guides installed
Part capacity…………………………1.00” to 6.00” OD X 90” long
Spindle Horsepower…………………….60 HP
RPM Range…………………………….150 to 600 low range / 600 to 1,500 high range
Drill Axis Feed……………………….0.500 To 24.0 Inches per minute plus rapid
Drive………………………………..AC Servo driven ballscrew
Spindle Lubrication……………………Automatic Air / Oil Mist
Ballscrew Lubrication………………….Automatic Oil
Ways Lubrication………………………Automatic Oil
Coolant System Model…………………..60-1000-160
Capacity……………………………..1000 Gallons
High Pressure Pumps……………………One 50/50 2 stage One 10/20/30 Three stage
Pump Motors…………………………..Two 30 HP AC
Maximum pressure………………………750 PSI @ 60 GPM
Filtration……………………………Four 10 Micron Disposable Bag Type
Heat Exchanger………………………..Water / Oil – (Standard)
Power Requirements…………………….460 V-3PH-60HZ
Control………………………………Allen Bradley SLC 500 series
Interface…………………………….Touch screen Operator station

EQUIPPED WITH:
Allen Bradley SLC 500 series Control
Hydraulic power chuck on tailstock spindle
Hinged belt type chip conveyor built into the recovery area of the coolant system
Sliding Guards

CONTROL:
•Consisting of a Nema 12 enclosure housing all motor starters, fuses, and disconnect.
•A touch screen operator station with automatic and manual functions plus E-stop, E-retract and cycle start.
•Complete diagnostic screen and fault message display.
•Digital display of RPM
•Drilling depths, feed rates and spindle RPM are programmable.
•Maximum travel limit switches to prevent over travel.
•Machine control, Allen Bradley SLC-500 series programmable control
•Automatic controls provide for detection of loss of coolant pressure, air pressure, and clogged filters.
•Tool load monitoring via spindle load and feed thrust-meter.
•Allen Bradley AC servo feed drive system
•ABB variable speed frequency inverter spindle drive.
•Two remote operator boxes with spindle jog, feed jog, E-retract and E-stop, each mounted to the tailstock and spindle to aid in operator set up and tool change.

**BUYER RESPONSIBLE FOR VERIFYING SPECIFICATIONS & OPTIONS**

Don't see the machine you are looking for? Email us or pick up the phone 602-516-4267 Dismiss